Anderson Manufacturing AV-9000 - Manual (Page 193)

Edition 3
Rev G
Section 6 6-1
Section 6 - Chart Prompts
From the Normal Display, press the . If the Chart Prompts are disabled, when the CHART key is pressed,
CHART KEY DISABLED will appear in the lower display. Refer to Section 9, Enables & Passwords, for instruc-
tions to enable Chart Prompts.
If the Chart Prompts are not disabled BUT the password is other than zero, CHART PROMPTS PASSWORD will
appear in the display when the CHART key is pressed. If the correct "password" is entered, CHANGE CHART
will appear in the upper display. If the incorrect "password" is entered, INVALID PASSWORD will appear in the
upper display.
If the Chart Prompts is not disabled AND the password is set to zero, when the CHART key is pressed, CHANGE
CHART will appear in the upper display.
For the prompts associated with the CHART key, the unit automatically goes into the modify mode, unless the
prompt is for SELECT CHART CONFIGURATION. For simplicity of operation etc., upon selection of a new
choice, the unit will automatically go into the modify mode, unless its a special case as noted below.
In this prompt section, use the CHART key to advance to the next prompt without modifying the current param-
eter.
IMPORTANT: The CHANGE CHART procedure shown below must be followed. If it is not, important
information (chart tags, time, scales, etc) may not be printed.
6.1 CHANGE CHART
1. Press the . CHANGE CHART appears in the upper display line and NO YES (NO blinking) appears in
the lower display line. If the chart has previously been stopped for changing, this prompt may not appear.
2. Select YES by pressing the key directly below the displayed YES or by pressing the or
until YES is blinking, then press the .
3. START NEW CHART appears in the top display and NO YES (NO blinking) appears in the bottom display.
4. Change the chart at this time.
5. Select YES by pressing the key directly below the displayed YES or by pressing the or
until YES is blinking, then press the .
(Continued on next page)