Anderson Manufacturing AV-9000 - Manual (Page 273)

Section 14 Edition 3
Rev G 14-2
7. Press the SCROLL key to advance to the next parameter, PxxSy SETPOINT 2 (if setpoints > 1). Press
the MOD key to change, then UP/DOWN to desired setpoint value, then press the ENTER key.
8. Press the SCROLL key to advance to the next parameter, PxxSy SETPOINT 3 (if setpoints = 3 or 4).
Press the MOD key to change, then UP/DOWN to desired setpoint value, then press the ENTER key.
9. Press the SCROLL key to advance to the next parameter, PxxSy SETPOINT 4 (if setpoints = 4). Press
the MOD key to change, then UP/DOWN to desired setpoint value, then press the ENTER key.
10. Press the SCROLL key to advance to the next parameter, PxxSy EVENT OUTPUTS during the ramp.
Eight digits will be displayed, one for each event: 0 = inactive, 1 = active. To change, press the MOD key,
a cursor appears under the left most digit. Use the UP/DOWN key to change the state as necessary, then
the ENTER. The cursor will move one position to the right. Repeat this procedure for each event.
11. Press the SCROLL key to advance to the next parameter, PxxSy DWELL TIME, displayed as
hhh:mm:ss where h is hours, m is minutes and s is seconds. Press the MOD key to change. Changes
are made the same as for Ramp Time.
12. Press the SCROLL key to advance to the next parameter, PxxSy EVENT OUTPUTS during the dwell.
To change, press the MOD key.
AFTER THE SEGMENT DATA IS ENTERED, THE FOLLOWING ARE DISPLAYED FOR THE PROFILE.
13. Press the SCROLL key to advance to the next parameter, Pxx GUARANTEED SOAK. Selections NO
or YES. Press the MOD key to change, then press the key directly below choice to enter.
Guaranteed Soak - If selected, this feature advances the soak time only when the process value
is within the specified deviation from setpoint. Therefore it guarantees that the load is soaked at
the specified setpoint. Deviation after ramp up and deviation after ramp down provides separate
deviations for each direction of setpoint ramping.
14. Press the SCROLL key to advance to the next parameter, Pxx SP1 DEVIATION ON RAMP UP (only if
Guaranteed Soak is set to YES). Selections 0-9999999. Press the MOD key to change, then press the
LEFT/SCROLL, UP/DOWN as required to desired deviation value, then press the ENTER key.
15. Press the SCROLL key to advance to the next parameter, Pxx SP1 DEVIATION ON RAMP DOWN
(only if Guaranteed Soak is set to YES). Selections 0-9999999. Press the MOD key to change, then
press the LEFT/SCROLL, UP/DOWN as required to desired deviation value, then press the ENTER key.
Note: Repeated for each setpoint configured.
16. Press the SCROLL key to advance to the next parameter, Pxx SEGMENTS LOOP COUNT.
Selections 0-9999. Press the MOD key to change, then the LEFT/SCROLL, UP/DOWN as required to
desired loop count, then press the ENTER key.
Segment Loop Count - The unit will cycle through the segments the number of times specified by
segment loop count before proceeding to the next phase, which is specified by the next
parameter. One = execute the segments once.
17. Press the SCROLL key to advance to the next parameter, Pxx WHEN SEGS DONE (only seen when
more than one profile has been specified). Selections: END and JOIN X (X=1-16). Press the MOD key to
change, then press the LEFT/SCROLL,UP/DOWN as required to desired choice, then press the ENTER
key.