Anderson Manufacturing AV-9000 - Manual (Page 275)

Section 14 Edition 3
Rev G 14-4
14.2 PROFILE SETTINGS
To enter the Profile Settings section, from the Normal Display, press the SCROLL key until CONFIGURATION
appears in the lower display line. With CONFIGURATION in the lower display line, press the DOWN key. Press
the SCROLL key until PROFILE SETTINGS appears in the lower display line.
1. With PROFILE SETTINGS in the lower display line, press the DOWN key, then the SCROLL key until
PROFILE ENTRY appears in the upper display line. Selections are: DISABLED DURING RUN or EN
ABLE DURING RUN. Press the MOD key to change, then UP/DOWN as required to desired choice, then
press the ENTER key.
Profile Entry - This parameter controls access to the PROFILE ENTRY section while the profile is
running; DISABLED prevents access while ENABLED allows access.
2. Press the SCROLL key to advance to the next parameter, PROFILE START ACTUATOR. See Actuator
List for selections. Press the MOD key to change, then LEFT/SCROLL, UP/DOWN as required to desired
choice, then press the ENTER key.
Profile Start Actuator - A transition from not active to active of the PROFILE START ACTUATOR
will initiate the selected profile.
3. Press the SCROLL key to advance to the next parameter, PROFILE SELECTOR. See Choice List for
selections. Press the MOD key to change, then LEFT/SCROLL, UP/DOWN as required to desired
choice, then press the ENTER key.
Profile Selector - Applies only when the PROFILE START ACTUATOR is used, and allows an
analog value, typically from an IV, to select the profile number to be initiated. Care must be taken
to insure that a valid value is provided. The value is automatically rounded to the nearest whole
number.
4. Press the SCROLL key to advance to the next parameter, PROFILE ABORT ACTUATOR. See Actua
tor List for selections. Press the MOD key to change, then LEFT/SCROLL, UP/DOWN as required to
desired choice, then press the ENTER key.
Profile Abort Actuator - If a transition is detected on the Profile Abort Actuator and a profile is
active, the profile is then aborted.
5. Press the SCROLL key to advance to the next parameter, PROFILE HOLD ACTUATOR. See Actuator
List for selections. Press the MOD key to change, then LEFT/SCROLL, UP/DOWN as required to desired
choice, then press the ENTER key.
Profile Hold Actuator - A positive transition of the Profile Hold Actuator places an active profile in
hold, while a negative transition places it in run. While in hold, the ramp/dwell timer stops.
6. Press the SCROLL key to advance to the next parameter, PROFILE ADVANCE ACTUATOR. See
Actuator List for selections. Press the MOD key to change, then LEFT/SCROLL, UP/DOWN as required
to desired choice, then press the ENTER key.
Profile Advance Actuator - A positive transition on the Profile Advance actuator will advance the
profile to the next step. The ramp time remaining or dwell time remaining will be set with a few
seconds so that the profile will step quickly to the next segment, yet do so without abruptly
changing the current segment or profile.