HP Insight Management Agents - Manual (Page 105)

◦ Missing-Was Offline—Indicates a physical drive that was located in the system and had
a status of offline has been removed.
◦ Solid State Disk Wear Out—Indicates that the solid state drive has a S.M.A.R.T wear error
and is approaching the maximum usage limit for writes (wear out). The solid state drive
should be replaced as soon as possible.
◦ Missing - Was Solid State Disk Wear Out —Indicates that a physical drive that was located
in the system and had a status of SSD wear out has been removed.
◦ Not Authenticated—The physical drive could not be authenticated as a genuine HP hard
drive. The host bus adapter will no longer control the drive LEDs. Please replace the hard
drive with a genuine HP hard drive.
◦ Missing - Was Not Authenticated—Indicates that a physical drive that was located in the
system and had a status of Not Authenticated has been removed.
◦ Unknown—The Storage Agents cannot determine the status of this physical drive. You
may need to upgrade your driver software or Storage Agents.
•
Serial Number—Displays the serial number assigned to the physical drive. This value is based
on the serial number as returned by the SCSI inquiry command, but may have been shortened
due to space limitations. Use this item for identification purposes.
•
Capacity —Displays the size of the physical drive. A megabyte (MB) is 1,048,576 bytes, a
gigabyte (GB) is 1,073,741,824 bytes, and a terabyte (TB) is a thousand gigabytes.
•
Many hardware manufacturers use a megabyte value of 1,000,000 instead of 1,048,576.
This may result in discrepancies between the manufacturer's stated size and the size reported
by this application.
•
Firmware Version—Displays the firmware revision level of the SAS physical drive.
•
Smart Carrier Application Firmware Version—Displays the physical drive smart carrier
application firmware version number of the Smart Carrier that passed authentication.
•
Smart Carrier Bootloader Firmware Version—Displays the physical drive smart carrier
bootloader firmware version number of the Smart Carrier that passed authentication.
•
Placement—Indicates if the physical drive is in an internal or external storage system. The
following values are valid:
◦ Internal—The physical drive is in an internal storage system.
◦ External—The physical drive is in an external storage system.
◦ Unknown—The physical drive is not in a storage system or the Storage Agents cannot
determine the drive placement.
—This symbol indicates that the drive is a hot plug drive.
•
Disk Type—Indicates the type of disk drive. The following values are valid:
SAS—The disk is a serial SCSI disk drive. ◦
◦ SATA—The disk is a Serial ATA disk drive.
◦ Unknown—The Storage Agents cannot determine the disk type.
Storage agent 105