HP Insight Management Agents - Manual (Page 38)

•
Daughter Board Type—Displays the type of daughter board installed on the array controller.
The following values are valid:
◦ Not Supported—Indicates that the array controller does not support daughter boards or
it does not support daughter board identification.
◦ Not Present—Indicates that a daughter board is not installed on the array controller.
◦ SCSI—Indicates that a SCSI daughter board is installed on the array controller.
◦ Fibre—Indicates that a Fibre daughter board is installed on the array controller.
◦ Array—Indicates that an Array Expansion Module is installed on the array controller.
◦ Unknown—Indicates that the daughter board type is not recognized. You may need to
upgrade the Storage Agents.
•
Rebuild Priority—Displays the logical drive rebuild priority of the controller. The following
values are valid:
◦ Low—Indicates the rebuild priority is low.
◦ Medium—Indicates the rebuild priority is medium.
◦ High—Indicates the rebuild priority is high.
◦ Unknown—Indicates that the rebuild priority is not recognized. You may need to upgrade
the Storage Agents.
•
Expand Priority—Displays the logical drive expand priority of the controller. The following
values are valid:
◦ Low—Indicates the expand priority is low.
◦ Medium—Indicates the expand priority is medium.
◦ High—Indicates the expand priority is high.
◦ Unknown—Indicates that the expand priority is not recognized. You may need to upgrade
the Storage Agents.
•
Number of Ports—Displays the number of usable SCSI ports on the controller. Sometimes port
is also referred to as bus or channel. The number of ports does not indicate the number of
connectors.
•
Internal Ports—Displays the number of internal connectors on the controller.
•
External Ports—Displays the number of external connectors on the controller.
•
Physical Drive Write Cache State—Displays the controller setting for physical drive write cache.
The following values are valid:
◦ Disabled—Indicates the controller will disable write cache on all physical drives.
◦ Enabled—Indicates the controller will enable write cache on all physical drives.
◦ Unknown—Indicates the drive write cache state is not recognized. You may need to
upgrade the Storage Agents.
◦ Current Temperature—lists the temperature of the array controller in degrees Celsius.
◦ Last Lockup Code—lists the lockup code of the array controller if a lockup occurred prior
to the last controller reset.
38 Agent information