HP Insight Management Agents User Manual
Page 109
◦
Unknown - The Storage Agents do not recognize the status of the fan subsystem. You may
need to upgrade your software.
◦
No Fan - This storage system does not have a fan.
•
Power Supply Status displays the status of the redundant power supply. The following values
are possible:
◦
OK - All component power supplies that make up the redundant power supply are in
normal working order.
◦
Degraded - One of the component power supplies that make up the redundant power
supply has failed. The drive system (either a drive subsystem or a power supply for the
main unit) continues to operate. However, if the remaining power supply should fail, the
drive system will lose all power and data loss could occur. To correct this situation,
schedule a time to bring the device down and replace the failed power supply.
◦
Unknown - The Storage Agents do not recognize the redundant power supply. You may
need to upgrade your software.
◦
No Redundant Power Supply - This storage system does not support a redundant power
supply.
•
Thermal Status displays the temperature status of the drive system. The following values are
possible:
◦
OK - The temperature is within normal operating range.
◦
Degraded - The temperature is outside of normal operating range. Make sure the cover
is on the storage system.
◦
Failed - The temperature is outside of normal operating range, and could permanently
damage the system. Ensure that the fans are spinning and check the room temperature.
◦
Unknown - The Storage Agents do not recognize the thermal status. You may need to
upgrade your software.
◦
No Temperature Monitoring - This storage system does not support temperature monitoring.
If the storage system uses Target Based Management (TBM), the following information with
regards to the storage box management will be displayed.
•
Initiator SAS Address displays the SAS address of the initiator connected to the drive box.
•
Target SAS Address displays the SAS address of the target (i.e. the drive box itself).
•
Primary Controller IP Address displays the management IP address for the storage box primary
controller.
•
Connection Status displays the drive box connection status. The following values are valid:
Connected - The storage system is connected.
◦
◦
Not Connected - The storage system is disconnected.
◦
Not Supported - Reporting this storage system's connection status is not supported.
◦
Unknown - The Storage Agent is unable to determine the storage system's connection
status. You may need to upgrade your software.
Storage agent 109