HP ProLiant SL230s Gen8 Server - Manual (Page 18)

Operations 18
Install the processor air baffle
1. Install the processor air baffle.
IMPORTANT: If the DIMM latches are not fully closed, the baffle will not sit properly.
2. Install the server into the chassis (" Installing the server into the chassis " on page 25 ).
3. Connect all peripheral cables and power cords to the rear panel.
4. Power up the server (on page 15 ).
Remove the PCI riser cage
1. Power down the server (on page 15 ).
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis (on page 15 ).
4. If an expansion board is installed, disconnect all cables connected to it.
5. Remove the PCI riser cage:
a. Remove the screw securing the PCI riser cage.