Acnodes Aficio AP4510 - Manual (Page 28)

Installing Options
18
2
MMMM
Close the connector cover.
Note
❒ Print a configuration page to
confirm that the Paper Bank is
properly installed. See "Printing
a Configuration Page" in the
Printer Reference on the CD-
ROM labeled "Operating In-
structions".
Installing Printer Hard Disk
Type4510
R CAUTION:
Important
❒ The Printer Hard Disk can be dam-
aged by a small amount of static
electricity. You should touch some
metal to discharge static electricity.
❒ When the bidirectional transmis-
sion is not in operation, you must
set up the installed Printer Hard
Disk using the printer driver in or-
der to use it. See p.37 “Installing
the Printer Driver and Software”
for setting up options. See p.48
“The conditions of the bidirection-
al transmissions” for information
about bidirectional transmission.
❒ When the Printer Hard Disk is be-
ing accessed, the Data In indicator
blinks. Do not turn off the printer
power when the Data In indicator
is blinking as it may destroy the
hard disk.
❒ When a print job is being spooled,
the printer sends data to the hard
disk, and the Data In indicator
blinks. Do not turn off the printer
or computer while a print job is be-
ing spooled, as it may destroy the
hard disk or the spooled job will
remain in the hard disk and be
printed repeatedly until erased.
AAAA
Check the contents of the box for
the following items:
• Printer Hard Disk
• Installation Guide
• Power Cord
• Connector
BBBB
Turn off the printer.
CCCC
Pull out the first paper tray (Tray
1) and take the screwdriver (
A A A A)
from the tray. Each screw to be re-
moved requires this screwdriver.
• Do not touch the inside of the
printer board compartment. It
may cause a machine malfunc-
tion or a burn.
ZFCP720E
Setup-F3_FM.book Page 18 Friday, October 5, 2001 8:27 PM