HP LaserJet P3005 Printer series - Manual (Page 131)

Control panel message Description Recommended action
● If the error appears while printing,
determine whether it occurs when
printing from a specific computer, a
specific application, or a specific file. If
all other computers, applications, or files
can print without the error, then the
problem may be only within one print job
or computer. Make sure the computer
has the most current printer drivers, or
use a generic printer driver.
● If the error occurs when the device is
first turned on, turn off the device,
disconnect the LAN cable, and then turn
on the device. This process will
determine if errors occur from the
network connection. If errors do not
appear when the LAN cable is
unplugged, it is possible traffic or signal
on the network might be causing the
error. Make sure to try all solutions
suggested, especially upgrading the
Jetdirect firmware.
● Disable the print server.
● For EIO print servers, remove the
card.
● For embedded print servers, use
the Service menu.
● If the problem persists, contact
HP Support.
8X.YYYY EMBEDDED JETDIRECT
ERROR The HP Jetdirect embedded print server has
encountered a critical error. ● Turn the device off and then on.
● If the problem persists, contact
HP Support.
<Date> <Time>
To change press
To skip, press STOP
The device has an internal clock that tracks
the date and time. You are prompted to set
the correct date and time the first time you
turn on the device. Press to change the date and time.
Press Stop to skip this step. You can set the
date and time later by using the SYSTEM
SETUP menu.
If the prompt appears each time you turn on
the device, the clock is not working correctly.
Contact HP support.
Access Denied MENUS LOCKED The device administrator has enabled the
control-panel security mechanism. You
cannot modify control-panel settings in this
circumstance. The message disappears after
a few seconds, and the device returns to
Ready or BUSY state. Contact the device administrator to change
settings.
ACTION NOT CURRENTLY AVAILABLE
ON TRAY X
alternates with
Tray size cannot be ANY SIZE/ANY
CUSTOM
You are trying to set duplex registration for a
tray that is configured for ANY SIZE or ANY
CUSTOM. Duplex registration is not available
when the tray size is set to either of these
settings. Change the size setting for the tray.
ENWW Control-panel messages 119