124 chapter 7 problem solving enww – HP LaserJet P3005 Printer series User Manual
Page 136
Control panel message
Description
Recommended action
Restoring factory settings
The device is restoring factory settings.
No action necessary.
RFU LOAD ERROR
An error has occurred during a firmware
upgrade.
●
Reinstall the firmware.
●
If the problem persists, contact
HP Support.
SANITIZING DISK X% COMPLETE
alternates with
DO NOT POWER OFF
The memory disk is being sanitized. This
process might take up to an hour. During this
time, no jobs can be printed.
Do not turn off the device. Wait for the
process to complete.
The device automatically restarts at the end
of the sanitation process.
Setting saved
A menu selection has been saved.
No action necessary.
SIZE MISMATCH IN TRAY XX
alternates with
Ready
The tray is loaded with a media size that is
different than the size for which the tray is
configured. Printing can continue from other
trays, but not from this one.
●
Make sure the media guides are
adjusted correctly.
●
In the PAPER HANDLING menu,
configure the tray for the correct size.
Sleep mode on
The device is in the sleep mode. Any button
press or the receipt of data clears sleep
mode.
No action necessary. The device
automatically exits sleep mode.
STANDARD TOP BIN FULL
alternates with
Remove all paper from bin
The output bin is full. Printing cannot
continue.
Empty the output bin. Printing resumes
automatically.
Tray X <TYPE> <SIZE>
alternates with
To change size or type press
The device is reporting the current
configuration of tray X.
No action necessary.
Press
to clear the message.
Press
to change the type or size.
See
TRAY XX EMPTY <TYPE> <SIZE>
alternates with
Ready
The tray is empty, but the current print job
does not require this tray.
Fill the tray. The message indicates the type
and size of media for which the tray is
currently configured.
TRAY XX OPEN
For help press
alternates with
Ready
The tray is open, but printing can continue.
Close the tray.
TRAY XX OPEN OR EMPTY
alternates with
Ready
The tray is open or empty, but the current
print job does not require this tray.
Close or fill the tray.
TYPE MISMATCH IN TRAY XX
alternates with
Ready
The tray is loaded with a media type that is
different than the type for which the tray is
configured. Printing can continue from other
trays, but not from this one.
In the PAPER HANDLING menu, configure
the tray for the correct type.
124
Chapter 7 Problem solving
ENWW