HP LaserJet M9059 Multifunction Printer series - Manual (Page 104)

Select the output bin
The MFP has at least two output bin locations: the ADF output bin (1) and an output bin on the output
device.
Figure 6-22 Output bins
It is recommended that you select an output location through the software program or printer driver.
Stacker or stapler/stacker output bins
If you choose the 3,000-sheet stacker or 3,000-sheet stapler/stacker, the output bins are the upper bin
(2) (face up) and the lower bin (3) (face down).
The upper bin (face-up) (2) is the top bin on the stacker or stapler/stacker. This bin holds up to 100
sheets of paper in face-up order as they exit the MFP. A sensor causes the product to stop when the
bin is full. Product operation continues when you empty or reduce the amount of paper in the bin.
The lower bin (face-down) (3) is the lower bin on the stacker or stapler/stacker. This bin holds up to
3,000 sheets of paper and allows you to stack or staple jobs. This bin is the default output bin.
8-bin mailbox output bins
If you choose the 8-bin mailbox, the output bins are the upper bin and the eight face-down bins.
The upper bin (4) holds up to 125 sheets of paper.
The network administrator can assign the eight bins (5) to individual users or workgroups. Each bin can
stack up to 250 sheets of paper.
Multifunction finisher output bins
If you choose the multifunction finisher, the output bins are the upper bin ( 6) and the lower booklet bin
(7).
The upper bin (6) is the top bin on the multifunction finisher. This bin provides 1,000 sheets of stacking
capacity and can offset each job as it is stacked, delivering unstapled jobs face up or face down. This
bin also provides stapling for up to 50 sheets of paper per document. The upper bin is the default output
bin when the multifunction finisher is attached.
The lower booklet bin (7) is the lower bin on the multifunction finisher. This bin provides folding and
saddle stitching of booklets for up to 10 sheets of paper.
90 Chapter 6 Paper and print media ENWW