Print on envelopes – HP LaserJet M9059 Multifunction Printer series User Manual
Page 120
Print on envelopes
Envelopes must be printed from tray 1, which holds up to 10 envelopes. Printing performance depends
on the construction of the envelope. Always test a few sample envelopes before purchasing a large
quantity. For envelope specifications, see
Supported paper and print media sizes on page 77
or go to
CAUTION:
Envelopes with clasps, snaps, windows, coated linings, exposed self-stick adhesives, or
other synthetic materials can severely damage the MFP. Do not use envelopes with pressure-sensitive
adhesive.
Use the following basic steps to print on envelopes.
1.
Load the envelopes in tray 1.
2.
Change the fuser levers.
3.
Send the print job.
Load envelopes in tray 1
1.
Open tray 1, but do not pull out the extension. (Most envelopes feed best without the extension.
However, oversize envelopes might need the extension.)
Figure 7-14
Load envelopes in tray 1 (1 of 3)
2.
Load up to 10 envelopes in the center of tray 1 with the side to be printed on facing up, and the
return-address end toward the MFP. Slide the envelopes into the MFP as far as they will go without
forcing them.
Figure 7-15
Load envelopes in tray 1 (2 of 3)
106 Chapter 7 Print tasks
ENWW