HP PSC 2350 All-in-One Printer User Manual
Page 107
After connecting and turning on your HP all-in-one, you might have to wait several
minutes for all of the Plug and Play events to complete.
9
Follow the onscreen instructions.
When the software installation is complete, the Status Monitor icon appears in the
Windows system tray.
To verify that the software is properly installed, double-click the HP Director icon on the
desktop. If the HP Director shows the key icons (Scan Picture, Scan Document, and
HP Gallery), the software has been properly installed.
To uninstall from a Windows computer, method 2
Note
Use this method if Uninstall Software is not available in the Windows Start
menu.
1
On the Windows taskbar, click Start, Settings, Control Panel.
2
Double-click Add/Remove Programs.
3
Select HP all-in-one & Officejet & OfficeJet 4.0, and then click Change/Remove.
Follow the onscreen instructions.
4
Disconnect your HP all-in-one from your computer.
5
Restart your computer.
Note
It is important that you disconnect your HP all-in-one before restarting your
computer. Do not connect the HP all-in-one to your computer until after you
have reinstalled the software.
6
Launch setup.
7
Follow the onscreen instructions and the instructions provided in the Setup Guide
that came with your HP all-in-one.
To uninstall from a Windows computer, method 3
Note
This is an alternate method if Uninstall Software is not available in the Windows
Start menu.
1
Run the HP PSC 2350 series all-in-one software Setup program.
2
Select Uninstall and follow the onscreen directions.
3
Disconnect your HP all-in-one from your computer.
4
Restart your computer.
Note
It is important that you disconnect your HP all-in-one before restarting your
computer. Do not connect the HP all-in-one to your computer until after you
have reinstalled the software.
5
Run the HP PSC 2350 series all-in-one software Setup program again.
6
Launch Reinstall.
7
Follow the onscreen instructions and the instructions provided in the Setup Guide
that came with your HP all-in-one.
To uninstall from a Macintosh computer
1
Disconnect the HP all-in-one from your Macintosh.
Chapter 13
104
HP PSC 2350 series all-in-one
Troubleshooting
information