HP PSC 2350 All-in-One Printer - Manual (Page 24)

3 Insert the installation CD that was supplied with the HP JetDirect into your
computer's CD-ROM drive.
You will use this CD to locate the HP JetDirect on the network.
4 Select Install to run the HP JetDirect installer.
5 When prompted, insert the HP all-in-one installation CD.
Note If you are performing an initial installation of your HP all-in-one and
HP JetDirect 175x, do not run the HP all-in-one setup wizard. Just install the
drivers following the instructions below.
If you decide at some later date to connect your HP all-in-one using a USB
cable, then insert the HP all-in-one installation CD and run the setup wizard.
6 Follow the steps appropriate for your operating system:
If you are using Windows XP or 2000:
a
Browse to the root directory of the CD and select the correct driver .inf for your
HP all-in-one.
The printer driver file, located in the root directory, is hpoprn08.inf.
If you are using Windows 98 or ME:
a
Browse the CD for the "Drivers" folder and find the correct language subfolder.
For example, for English speaking customers, navigate to the \enu\drivers
\win9x_me directory, where enu is the English language directory and
win9x_me is for Windows ME. The printer driver file is hpoupdrx.inf.
b Repeat for each of the drivers required.
7 Complete the installation.
To network connect your HP all-in-one using the HP JetDirect 175x (Macintosh)
1 Follow the HP JetDirect 175x setup instructions to connect the print server to a
LAN.
2 Connect the HP JetDirect to the USB port on the rear of your HP all-in-one.
3 Do one of the following:
–
If you are performing an initial installation of your HP all-in-one, make sure you
insert the HP all-in-one installation CD into the CD-ROM drive on your
computer and run the HP all-in-one setup wizard.
The network support software for your computer is installed at this time.
When the installation is finished, the HP All-in-One Setup Assistant appears
on your computer.
– From the Disk Drive, open the HP All-in-One Setup Assistant from the
following location: Applications:Hewlett-Packard:HP Photo & Imaging
Software:HP AiO Software
The HP All-in-One Setup Assistant appears on your computer.
4 Follow the onscreen prompts and provide the information requested.
Note Make sure you click TCP/IP Network on the connection screen.
User Guide 21
Connection information