HP PL4245N 42 inch HD-ready Plasma Television - Manual (Page 27)

Using the TV 21
6 Use the Left or Right arrow buttons to highlight Add or Erase. Press the Enter button to add or erase
the current channel.
7 Press the EXIT button on your remote control to return to your TV display.
Turning off the TV
Press the Power button on the front panel or on the remote control to turn off the TV. The
Power/standby indicator light becomes amber. The TV is in standby.
If the TV is not used for an extended period of time, turn off the main power switch.
Selecting the input source
Select the input source for the main picture and the PIP using the front panel buttons or the remote
control buttons.
Using the remote control buttons
Press the TV button (below the remote control indicator light) to select the TV as the controlled home
entertainment device, and then press one of these input source buttons at the bottom of the remote
control:
DVI/VGA selects the input sources connected to the DVI or VGA (RGB) connectors.
YCbCr selects the input source connected to the Component Video Input (YCbCr).
YPbPr selects the input sources connected to the Component Video Inputs (YPbPr).
AV selects the input sources connected to the Composite Video Inputs.
SV selects the input source connected to the S-video Input.
CH (+) (–) selects the input from the TV antenna/cable in the RF connector.
Selecting the main picture input source using the front panel buttons
Press the Select button repeatedly until you see the desired input source.
Selecting the PIP input source using the remote control buttons
Press the TV button (below the remote control indicator light) to select the TV as the controlled home
entertainment device, press PIP Input to select the source for PIP.
Adjusting volume
1 Press and hold the VOL+ button (on the remote control or on the TV) to increase to the desired level.
2 Press and hold the VOL– button (on the remote control or on the TV) to decrease to the desired
level.
Muting sound
Press the Mute button on the remote control to cancel the sound; press it again to restore sound.