HP StoreAll Storage - Manual (Page 157)

NOTE: The ibrix_objectstore command collects information from the Object Store configured
nodes and lists the information. If an Object Store configured node goes down and if the Fusion
Manager fails over, this command will not display Object Store information about the nodes that
are down until the Object Store configured node comes up and is running again.
Viewing source and backup container replication configuration
To view the backup source containers and backup container for an Object Store:
1.
In the left Navigator pane, select Object under File Shares and Object Store.
2. In the lower-left pane, select Object Store Container Sync under Object Store.
3. In the lower-right pane, under Object Store Container Replication Configuration, the Backup
Target and the Backup Source configurations are displayed with their respective FQDN/IP
addresses of proxy endpoints.
Extend an Object Store
The Object Store service gets deployed on newly added nodes after performing this operation and
objects that have been added previously to the Object Store share are redistributed across the
recently added node pair, and new endpoints are added so that the load can be balanced. After
extending an Object Store configuration to the new couplet, administrative users in the swift group
(AD and LDAP) are granted administrative privileges on the newly added nodes.
Managing and monitoring Object Store 157