HP ProLiant DL385 G2 Server - Manual (Page 69)

Configuration and utilities 69
4. Select the ROM version.
5. Press the Enter key.
6. Press the Esc key to exit the current menu or press the F10 key to exit RBSU. The server restarts
automatically.
To access the redundant ROM manually:
1. Power down the server (on page 23 ).
2. Remove the access panel (on page 24 ).
3. Set positions 1, 5, and 6 of the system maintenance switch to On.
4. Install the access panel (on page 25 ).
5. Power up the server (on page 23 ).
6. Wait for the server to emit two beeps.
7. Repeat steps 1 and 2.
8. Set positions 1, 5, and 6 of the system maintenance switch to Off.
9. Repeat steps 4 and 5.
When the server boots, the system identifies whether the current ROM bank is corrupt. If a corrupt ROM is
detected, the system boots from the backup ROM and alerts you through POST or IML that the ROM bank
is corrupt.
If both the current and backup versions of the ROM are corrupt, the server automatically enters ROMPaq
disaster recovery mode.
USB support
HP provides both standard USB support and legacy USB support. Standard support is provided by the
operating system through the appropriate USB device drivers. HP provides support for USB devices prior
to the operating system loading through legacy USB support, which is enabled by default in the system
ROM. HP hardware supports USB version 2.0.
Legacy USB support provides USB functionality in environments where USB support is normally not
available. Specifically, HP provides legacy USB functionality at:
• POST
• RBSU
• Diagnostics
• DOS
• Environments which do not support USB natively
For more information on ProLiant USB support, refer to the HP website
( http://www.compaq.com/products/servers/platforms/usb-support.html ).
Changing the USB version support
The factory default setting for this server is USB version 1.1. After the OS has loaded, this setting can be
changed to USB version 2.0 using the following steps:
1. Access RBSU by pressing F9 during power up.
2. Select System Options.