HP Surestore Disk Array 12h and FC60 - Manual (Page 175)

Installing the Controller 175
Inst
alla
tion
5. If installing in an HP rack, secure the back of the enclosure to the rails using the two rail
clamps from the rail kit.
In legacy HP racks:
a. Align screw holes and insert the clamp tab into the slot in the upper surface of the
rail.
b. Insert a screw through the hole in the clamp and the rail and tighten with a Torx T25
screwdriver.
In HP Rack System/E racks:
a. Set the clamp (E in Figure 63 ) inside the rail with the holes in the clamp along the
slots in the rail.
b. Push the clamp tight against the back of the disk enclosure. The curved tip of the
clamp should overlap the bottom edge of the power supply slot.
c. Insert and tighten two M5 16mm screws (F in Figure 63 ) through each clamp and rail.