HP ProLiant ML350e Gen8 Server - Manual (Page 24)

Operations 24
Remove the security bezel
Unlock the security bezel, press the latch on the security bezel, and then remove the security bezel.
Remove the rack bezel
To remove the component:
1. If installed, remove the security bezel (on page 24 ).
2. Press the Power On/Standby button.
The server powers down and enters standby mode. The system power LED changes from green to
amber. Power is still applied to the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Extend the server from the rack (on page 27 ).
5. Remove the access panel (on page 25 ).
6. Loosen the thumbscrews.