HP ProLiant ML350e Gen8 Server - Manual (Page 77)

Hardware options installation 77
16. Do one of the following:
o For tower models, install the bezel (" Install the tower bezel " on page 23 ).
o For rack models, if removed, install the security bezel (" Security bezel option " on page 47 ).
Installing an expansion board
To install the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 22 ).
o For rack models, if installed, remove the security bezel (on page 24 ).
2. Power down the server (on page 22 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 27 ).
5. Remove the access panel (on page 25 ).
6. If installed, remove PCI air baffle (" Remove the PCI air baffle " on page 28 ).
7. Remove the system air baffle (" Remove the PCI air baffle " on page 28 ).
8. Remove the fan cage (on page 31 ).
9. Remove the full-length expansion board retainer, if any full-length expansion boards are installed.
10. Remove the expansion slot cover.
11. Install the expansion board.
12. Connect any required internal or external cables to the expansion board. See the documentation that
ships with the expansion board.