GE GTDS850GDWS - Manual (Page 12)

Installation Instructions
12
2
1
ABOUT REVERSING THE DOOR
SWING
IMPORTANT NOTES:
· Read the instructions all the way through before starting.
· Handle parts carefully to avoid scratching paint.
· Set screws down by their related parts to avoid using them in
the wrong places.
· Provide a non-scratching work surface for the door. · Normal
completion time to reverse the door swing is 30–60 minutes.
IMPORTANT:
Once you begin, do not move the cabinet until door-swing
reversal is completed. These instructions are for chan- ging
the hinges from the right side to the left side - if you ever
want to switch them back to the right side, follow these same
instructions and reverse all references to the left and right.
Tools Needed
Standard #2 Phillips Screwdriver
Tape-tipped putty knife
6PDOOÀDWEODGHVFUHZGULYHU
Before you start
Unplug the dryer from its
electrical outlet
Open the door to approximately 170 degrees.
With a putty knife, remove the 4 plastic covers located
along the left side of front panel and set them aside.
Remove the bottom screw from each hinge (right side) and
partially insert them into the top left side hinge holes.
NOTE: All 4 front panel hinge screws will now be in the
top hinge holes - 2 on the left and 2 on the right.
Plastic Cap (4)
3 Loosen the bottom 2 right side hinge screws. Remove
WKHGRRUDQGSODFHLWRQDSURWHFWHGÀDWVXUIDFHWRDYRLG
any damage. Remove both the Blind Plate and the Strike
Plate and install them in opposite positions.
4
Remove the 4 door hinge screws, 8 edge screws, and 4
LQVLGHVFUHZV/LIWWKHLQQHUGRRUXSZDUGVXVLQJDÀDW
blade screwdriver.
REVERSING THE DOOR
SWING
SOLID DOOR MODELS:
GTDP740ED0WW
GTDP740GD0WW
GTDL740ED0WW
GTDL740GD0WW
15