GE GTDS850GDWS - Manual (Page 15)

Installation Instructions
15
6 When the cover cap and door handle in place, mount
the inner door back into the outer door with the screws
removed in step 4. Make sure you mount the hinges on
the side opposite the handle. 5 Remove and swap the cover cap and door handle from
the outer door:
A. Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B. Squeeze the tabs on the inside of the cover cap.
Push cap through the outer door.
C. Push the door handle clips into the openings on the
RSSRVLWHVLGHRIWKHRXWHUGRRUPDNLQJVXUH\RXÀLS
the handle so it curves to the inside.
D. Push the cover cap into the openings on the outer
door where the handle was removed.
8 Install the 4 plastic caps removed in step 1 into the 4
right side front panel holes.
NOTE: To return the door to the original setup, follow
threse instructions, swapping “left” and “right”.
7
Mount the assembled door on the 2 upper left side hinge
screws installed in step 2.
Move the hinge screws loosened in step 3 into the lower
OHIWVLGHVFUHZKROHVDQG¿UPO\WLJKWDOOVFUHZV