GE GTDS850GDWS - Manual (Page 17)

Installation Instructions
17
6 When the cover caps and door handle in place, mount
the inner door back into the outer door with the screws
removed in step 4. Make sure you mount the hinges on
the side opposite the handle. 5 Remove and swap the 2 cover caps and door handle
from the outer door:
A. Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B. Squeeze the tabs on the inside of the cover caps.
Push caps through the outer door.
C. Push the door handle clips into the openings on the
RSSRVLWHVLGHRIWKHRXWHUGRRUPDNLQJVXUH\RXÀLS
the handle so it curves to the inside.
D. Push the cover caps into the openings on the outer
door where the handle was removed.
Edge
screws
Door
hinge
screws
Inside screws
Inside screws
Handle
8 Install the 4 plastic caps removed in step 1 into the 4
right side front panel holes.
NOTE: To return the door to the original setup, follow
these instructions, swapping “left” and “right”.
7
Mount the assembled door on the 2 upper left side
hinge screws installed in step 2. Move the hinge screws
loosened in step 3 into the lower left side screw holes.
Tighten those screws enough to hold the door but still
allow a slight adjustment. Close the door. Adjust the door
so there is equal gap on all sides. Carefully open the door
DQG¿UPO\WLJKWHQDOOVFUHZV