GE GTDS850GDWS - Manual (Page 16)

Installation Instructions
16
14
2
1
Open the door to approximately 170 degrees.
With a putty knife, remove the 4 plastic covers located
along the left side of front panel and set them aside.
Remove the bottom screw from each hinge (right side)
and partially insert them into the top left side hinge
holes.
NOTE: All 4 front panel hinge screws will now be in the
top hinge holes - 2 on the left and 2 on the right.
Plastic Cap (4)
3 Loosen the bottom 2 right side hinge screws. Remove the
GRRUDQGSODFHLWRQDSURWHFWHGÀDWVXUIDFHWRDYRLGDQ\
damage.
Remove both the Blind Plate and the Strike Plate and
install them in opposite positions.
4 Remove the 4 door hinge screws, 4 edge screws, and
LQVLGHVFUHZV/LIWWKHLQQHUGRRUXSZDUGVXVLQJDÀDW
blade screwdriver.
REVERSING THE DOOR SWING
GLASS PANEL DOOR MODELS:
GTDS810ED0WS
GTDS810GD0WS
GTDS815ED0MC
GTDS815GD0MC
GTDS820ED0WS
GTDS820GD0WS
GTDS825ED0MC
GTDS825GD0MC
GHDS830ED0WS
GHDS830GD0WS GHDS835ED0MC
GHDS835GD0MC
GTDS850ED0WS
GTDS850GD0WS
GTDS855ED0MC
GTDS855GD0MC
GTDS860ED0WS
GTDS860GD0WS
GTDS865ED0MC
GTDS865GD0MC
Door hinge
screws
Inner door
Outer door
Inside screws
Inside screws
Edge
screws