GE PT970DRWW - Manual (Page 41)

41
GEAppliances.com
Oven Racks
Clean the oven racks with an abrasive cleanser
or steel wool. After cleaning, rinse the racks
with clean water and dry with a clean cloth.
Note: Porcelain-coated oven racks may remain
in the oven during the self-cleaning cycle
without being damaged. The shiny, silver-
colored oven racks may be cleaned in the
self-cleaning oven. However, they will darken
in color, loose their luster and become hard to
slide.
To make the racks slide more easily, apply a
small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
racks with the paper towel.
Oven rack
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface in
the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel
surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call our
toll-free number:
National Parts Center
1.800.626.2002
GEAppliances.com
Stainless Steel Surfaces
(on some models)
6+2&.25%851+$=$5' Before replacing oven light bulb, disconnect the electrical
power to the oven at the main fuse or circuit breaker panel. Failure to do so may result
in electric shock or burn.
WARNING
%851+$=$5' 7KHJODVVFRYHUDQGEXOEVKRXOGEHUHPRYHGZKHQFRRO7RXFKLQJKRW
glass with bare hands or a damp cloth can cause burns.
CAUTION
Oven Light Bulb
NOTE: The glass cover should be removed only
when cold. Wearing latex gloves may offer a
better grip.
Before replacing the bulb, disconnect electrical
power to the oven at the main fuse or circuit
breaker panel. Let the bulb cool completely
before removing it. For your safety, do not
touch a hot bulb with a damp cloth. If you do,
the bulb will break.
To remove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear the
grooves of the socket. Remove the bulb.
To replace:
Put in a new 40-watt appliance bulb. Place the
tabs of the glass cover into the grooves of the
socket. Turn the glass cover clockwise 1/4 turn.
NOTE:
„ A 40-watt appliance bulb is smaller than a
standard 40-watt household bulb.
„ Install and tighten the cover clockwise.
„ Reconnect electrical power to the oven.
„ For improved lighting inside the oven, clean
the glass cover frequently using a wet
cloth. This should be done when the oven is
completely cool.
Bulb
Socket
Tab
Maximum
length
3 1 ø
2
”
Glass cover