Asus P1-AH1 - Manual (Page 71)

5-11 ASUS Pundit P1-AH1
5.3.3 Primary IDE Master/Slave;
First/Second SATA Master
Primary IDE Master [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, Setup automatically fills in the correct values for
the remaining fields on this sub-menu. If automatic detection fails, this may
be because the hard disk drive is too old or too new. If the hard disk was
already formatted on an older system, Setup may detect incorrect
parameters. In these cases, select [Manual] to manually enter the IDE
hard disk drive parameters. Refer to the next section for details.
Configuration options: [None] [Auto] [Manual]
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
Primary IDE Master [Auto]
Access Mode [Auto]
Capacity XX MB
Cylinder XXXXX
Head XX
Sector XXX
PIO Mode [Auto]
UDMA Mode [Auto]
Transfer Mode UDMA5
Select Menu
Item Specific Help
Press [Enter] to
select.
IDE Primary Master
Access Mode [Auto]
This item allows the user to select the sector addressing mode.
Configuration options: [CHS] [LBA] [Large] [Auto]
PIO Mode [Auto]
This option lets you set a PIO (Programmed Input/Output) mode for the
IDE device. Modes 0 through 4 provide successive increase in
performance. Configuration options: [Auto] [Mode 0] [Mode 1] [Mode 2]
[Mode 3] [Mode 4]