Brewer Access High-Low - Manual (Page 16)

Document # 100452 RevL 16 Printed in USA © 2013
TABLE ADJUSTMENTS (continued)
Caution: Maximum Total Load 3A
Manual Pelvic Tilt
(Models 6001, 6501 and 6801)
The manual pelvic tilt feature sets the seat angle at 0°
(horizontal) or 5° (up) position.
Pull up on the front of the seat and the pelvic tilt auto-
matically travels to the locked tilt position (Figure 29).
Note: pulling up with excessive force can damage the
pelvic tilt mechanism. Lift only with enough force to
engage mechanism. Lift the adjustment lever and lower
the seat to the horizontal position.
CAUTION
Patient must be removed from table prior to lower-
ing the seat.
Figure 29. Pelvic Tilt Adjustment
Pelvic Tilt Adjustment Bar
Outlet
(Models 6501 and 6801)
(Optional on 6001)
Drawer Warmer
(Models 6001,
6501 and 6801)
Front Drawer Warmer
(Models 6001, 6501 and 6801)
Models 6001,6501 and 6801 are equipped with a drawer
warmer that is turned on by a switch located above the
drawer (Figure 30).
Note: Do not stack instruments in the front drawer. Place
instruments in one layer in the bottom of the drawer.
Note: This switch is for the drawer warmer only. The
On/Off switch for the table functions is located on the
back of the table (Figure 14).
Outlet
(Models 6001, 6501 and 6801)
Models 6001,6501 and 6801 are equipped with
an Outlet (Figure 31). The total amperage rating
for the table is 3 amps. The maximum total load
that can be plugged into the outlet is 2 amps.
Figure 30. Front Drawer Warmer Switch
Figure 31. Table Outlet