Brewer Access High-Low - Manual (Page 6)

Document # 100452 RevL 6 Printed in USA © 2013
INSTALLATION (continued)
Figure 7. Table Lift Points
Lift table at these points only
Slide drawer and
lift here
Pull Leg Support out
slightly and lift here. Do not
lift by the Leg Extension.
See Figure 4.
Figure 8. DO NOT Push on Backrest
Figure 5. Stirrups & Leg Support
Figure 6. Do Not Lift by Upholstery
Do Not Use
Leg Extension
to Lift
DO NOT LIFT BY
STIRRUPS!
Use Leg
Support
6. Remove the gray power cord from the rear drawer.
Plug the power cord into the socket at the bottom of
the rear panel (Figure 10). Plug the power cord into
a 120 Volt grounded receptacle.
7. Make sure the black On/Off Switch at the back of the
table is on (Figure 14 ).
8. Depress the switch on the foot control for lifting the
seat section until all the weight is removed from the
wooden U-shaped brace. Remove the brace and
spacers.
9. Unplug the power cord from the table and the
receptacle. Remove the foot control from the table.
Observe the following cautions when lifting the table
from the pallet.
• Do not lift table by stirrups (Figure 5).
• Lift front of table by leg support (Figure 5). Pull leg
support (not leg extension) out approximately 6”.
• Do not lift by upholstery (Figure 6).
• Lift rear of table by pushing top rear pass-through
drawer to one side and using opening as a hand hold
(Figure 7) .
• Whenever moving table, lift and lower. Do not drag
table. Damage to the levelers may occur.
• Do not push on backrest. Damage to the actuator
(mechanism that raises and lowers the backrest may
occur (Figure 8).