Removing the faceplate from the base, Mounting the base to a wall – AMX ENV-VST-C User Manual
Page 10
Installation and Wiring
4
ViewStat Color Communicating Thermostat
Removing the Faceplate from the Base
No tools are required to disassemble the thermostat—simply use your hands to pull the front panel off of
the base.
Mounting the Base to a Wall
You should only mount the ViewStat Color Communicating Thermostat onto a sheetrock wall with the
anchors and screws provided with the unit. There are four screw holes located on the base of the
thermostat.
1.
Place the base over the wire hole opening in the wall. Level the base (leveling required for
appearance only) and mark the screw hole mounting locations.
2.
Using the supplied wall anchors, drill 1/4" hole in the center of the marked locations, and tap the
wall anchors into the holes. If using the supplied screws only, drill a 3/32" hole in the center of the
marked locations.
3.
Fasten the base to the wall with the supplied screws.
4.
Seal the wire entry with caulk, drywall putty, or insulation.
Loss of internal programs may result from static discharge to the thermostat circuit board. Touch a
grounded metal object to discharge any static charge before handling the circuit board.
Minimize the wire entry hole size and seal. Drafts from inside the wall could affect temperature
readings.