Equus 3130 - Scan Tool – OBD2 - Manual (Page 12)

About the Scan Tool
ADJUSTMENTS AND SETTINGS
10 OBD2
E
Setting the Unit of Measurement
1. Use the UP and DOWN but-
tons, as necessary, to highlight Unit of
Measurement in the MENU, then press
the ENTER/LD
button.
2. Press the UP or DOWN button,
as necessary, to highlight the desired
Unit of Measurement.
3. When the desired Unit of Measurement
value is selected, press the ENTER/LD
button to save your changes.
Exiting the MENU Mode
1. Use the UP and DOWN buttons, as necessary, to highlight
Menu Exit in the MENU, then press the ENTER/LD button.
■ The display returns to the DTC screen (if data is currently stored
in the Scan Tool) or to the "To Link" message (if no data is cur-
rently stored in the Scan Tool).