Equus 3130 - Scan Tool – OBD2 - Manual (Page 42)

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
40 OBD2
E
1. With the Scan Tool in "Live Data" mode
(see Viewing Live Data on page 35 for
details), press and hold the ENTER/LD
button until the "Mode Selection
Menu" appears.
2. Use the UP and DOWN but-
tons, as necessary, to highlight “Live
Data Menu”, then press the ENTER/LD
button.
■ The "Live Data Menu" displays.
3. Use the UP and DOWN but-
tons, as necessary, to highlight “Record
Live Data”, then press the ENTER/LD
button.
■ The "Record Live Data Menu" dis-
plays.
4. Use the UP and DOWN buttons, as necessary, to highlight
“Record by manual trigger”, then press the ENTER/LD button.
5. When the "Record by Manual Trigger" screen displays, select the
desired trigger point as follows:
The Scan Tool is capable of recording approximately 20
frames of Live Data. Record by DTC trigger lets you select
the point in time at which you wish the Scan Tool to begin
recording Live Data. You can set the trigger point to record
the 20 frames of data before an event (when the DTC was
set), after the event, or in the middle (10 frames before and
10 frames after the event.
■ Beginning - records approximately
20 frames of Live Data after the
ENTER/LD button was pressed.
■ Middle - records approximately 10
frames of Live Data before and 10
frames after the ENTER/LD but-
ton was pressed.
■ End - records approximately 20 frames of Live Data before the
ENTER/LD button was pressed.
6. Use the UP and DOWN buttons, as necessary, to select the
desired trigger point, then press the ENTER/LD button.