Equus 3130 - Scan Tool – OBD2 - Manual (Page 8)

About the Scan Tool
VEHICLES COVERED / BATTERY REPLACEMENT
6 OBD2
E
On some Asian and European vehicles the DLC is located
behind the “ashtray” (the ashtray must be removed to access
it) or on the far left corner of the dash. If the DLC cannot be
located, consult the vehicle’s service manual for the location.
BATTERY REPLACEMENT
Replace batteries when the battery symbol is visible on display
and/or the 3 LEDS are all lit and no other data is visible on screen.
1. Locate the battery cover on the back of the Scan Tool.
2. Slide the battery cover off (use your fingers).
3. Replace batteries with three AA-size batteries (for longer life, use
Alkaline-type batteries).
4. Reinstall the battery cover on the back of the Scan Tool.
Language Selection After Battery Installation
The first time the Scan Tool is turned on, you must select the desired
display language (English, French or Spanish). Select the display lan-
guage as follows:
1. Press and hold the POWER/LINK
button for approximately 3 seconds to
turn the Scan Tool “ON.”
■ The Select Language screen displays.
2. Use the UP and DOWN but-
tons, as necessary, to highlight the
desired display language.
3. When the desired display language is
selected, press the ENTER/LD
button to confirm your selection.
■ The display shows the "To Link" mes-
sage in the selected display lan-
guage. Press the POWER/LINK
button to turn the Scan Tool "off."
■ After the initial language selection is performed, it as well as
other settings can be changed as desired. See ADJUSTMENTS
AND SETTINGS on page 7 for further instructions.