Equus 3130 - Scan Tool – OBD2 - Manual (Page 43)

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
OBD2 41
E
■ A "One moment please. . ." message
shows on the display. When the Scan
Tool is ready to record Live Data, the
"Record Live Data" screen displays.
7. Put the engine in the operating condition
where the problem manifests itself.
■ If necessary, drive the vehicle until
you reach the vehicle speed at which
the problem occurs.
8. When the problem occurs, press and
release the ENTER/LD button.
■ All three LEDs will blink for three sec-
onds to indicate that Live Data is
being recorded, and a "One moment
please. . ." message shows on the
display.
■ When recording is complete, a confir-
mation screen displays, asking if you
would like to view the recorded data.
Use the UP and DOWN but-
tons, as necessary, to select Yes or
No, as desired, then press the
ENTER/LD button.
If Yes is selected, the Scan Tool enters "Playback" mode from
which you can view a frame-by-frame playback of recorded
Live Data (see Live Data Playback on page 42 for details). If
No is selected, the display returns to the "Live Data View"
mode.
9. You can exit the "Record Live Data Mode" at any time by pressing
and holding the ENTER/LD button until the "Mode Selection
Menu" displays.
If desired, you can transfer the recorded Live Data informa-
tion to a personal computer using the optional PC-LINK pro-
gram (see instructions included with PC-Link for more infor-
mation).
Important Information
1. When Live Data capture is initiated, the green, yellow and red LEDs
on the Scan Tool will flash three times to indicate that Live Data is
being saved to the Scan Tool's memory.