HUACAM HCV704 - Manual (Page 20)

www.huacam.com 20
Figure 6: Networking Setting Page
‹ IP Address Configuration: Camera IP address configuration
• Dynamically Associated via DHCP: Default setting, DHCP server assign IP to
camera.
• Statically Configured as: Static IP address configuration
‹
DNS Configuration: DNS server IP, must be configured correctly if using static IP.
‹
HTTP: Web access TCP port, default 80.
NOTE:
— If camera behind SOHO router with port forwarding configuration for remote access, static IP
or static DHCP has to be used to avoid IP address change after router reboot.
— TCP port above 5000 suggested if port forwarding HTTP remote access, due to some ISP
would block port 80 inbound traffic. For example, change the default HTTP port from 80 to
8088, to make sure the port forwarding not likely be blocked.
— In addition to HTTP port, RTSP port also required to be configured for port forwarding, in
order for remote party viewing the H.264 video.
— If change the default port from TCP 80 to port “A”, then RTSP port should be “2000+A”. Both