HUACAM HCV704 - Manual (Page 39)

www.huacam.com 39
5.15 Configuration File Download
Huacam SIP Device can be configured via Web Interface as well as via Configuration File
through TFTP or HTTP/HTTPS. “Config Server Path” is the TFTP or HTTP/HTTPS server path
for configuration file. It needs to be set to a valid URL, either in FQDN or IP address format. The
“Config Server Path” can be same or different from the “Firmware Server Path”.
A configuration parameter is associated with each particular field in the web configuration page.
A parameter consists of a Capital letter P and 1 to 3 (Could be extended to 4 in the future) digit
numeric numbers. i.e., P2 is associated with “Admin Password” in the ADVANCED SETTINGS
page. For a detailed parameter list, please refer to the corresponding firmware release
configuration template.
When Huacam Device boots up or reboots, it will issue request for configuration file named
“cfgxxxxxxxxxxxx.xml”, where “xxxxxxxxxxxx” is the MAC address of the device, i.e.,
“cfg000b820102ab.xml”. The configuration file name should be in lower cases.
Currently HCV704 only support XML configuration.
6. Restore factory default setting
WARNING!
Restoring the Factory Default Setting will DELETE all configuration information of the camera.
Please BACKUP or PRINT out all the settings before approach to following steps. Huacam will
not take any responsibility if you lose all the parameters of setting or cannot connect to your VoIP
service provider.
6.1 Factory reset
Reset from Web Interface