Agilent Technologies DP111 User Manual
Page 45
User Manual: Agilent Acqiris 8-bit Digitizers
Page 45 of 59
completed. This thread is put to sleep, and wakes up upon reception of the interrupt from the instrument, or
after a 2 seconds timeout.
Please note that switching the DMA data transfer mode off precludes the use of acquisition interrupts. The –i switch
will therefore be ignored when –n is used.
Transient Recorder mode
The application will start in the Transient Recorder mode as opposed to the oscilloscope mode
Simulation Mode
Simulation mode allows you to run AcqirisLive without having any digitizer installed in the PC.
Temperature Update
The internally measured temperature of the currently selected module is normally displayed. Using this switch turns
this feature off.
Acquisition State
This switch turns on the display of the current acquisition state (Stopped, Ready, Started, Reading, Data ready). This
is helpful when running with time-consuming settings (e.g. many segments overlaid, many channels, large records,
etc.), but will slow down the overall performance.
Multi-instruments
By default, AcqirisLive tries to detect instruments connected through AS bus, and will initialize any connected
digitizers as a multi-instrument. This behavior can be inhibited by the -x switch, in which case any AS bus connector
will be ignored.