Agilent Technologies DP111 - Manual (Page 47)

User Manual: Agilent Acqiris 8-bit Digitizers Page 47 of 59
correspond to your expectations you may have hardware problems (unpowered, broken, or badly cabled crates or
modules).
The next step is to associate each bus segment with a physical crate. The menu to do this is shown below:
Selecting a row will cause all of the LED's of modules in that Bus to be turned on RED. This should make it easy to
identify which crate the modules are in.
The third step is to specify the number of slots in each crate. This is shown below:
The 4 th step consists of arranging the modules of each crate into the correct order. The menu shown below is one in
which all of this work has been done for the modules of a fully populated CC121. Selecting a position will cause a
module to have its red LED turned on. Then the Up and Down buttons will allow you to move the module in
question to the desired "Position in crate". For the PCI case physical position increases from left to right when
looking at the front panels of the digitizers with the connector towards the bottom. This numbering convention also
applies to cPCI crates from other manufacturers.