Argosy Research Mobile Video HDD - Manual (Page 23)

19
Using the AV Playback Function
Video Setup
This sub-menu can be set only after the
playback is stopped.
TV Standard
MULTI : According to the TV, outputs
the corresponding signal.
NTSC : Outputs NTSC signal to TV.
PAL :
Outputs PAL signal to TV.
If the setting is incorrect, the TV screen will not display normally. Switch to the
correct setting by pressing and holding button and then press MENU.
TV Display
4:3 PS : 4:3 screen TV is connected. Displays the 16：9 images with “Pan Scan”.
4:3 LB : 4:3 screen TV is connected. Displays the 16：9 images with “Letter Box”.
16:9 :
Connects to a 16:9 wide screen TV.
Picture Mode
If your TV is equipped with Progressive Scan function, setting this function may get better
picture quality output. If you have a traditional TV, leave it as “SUPER SMART”.
AUTO : Follows the contents to output the picture mode.
FILM : Always output progressive scan.
VIDEO : Always output interlaced scan.
SMART : Same as “AUTO”, and tries to enhance the picture quality.
SUPER SMART : Same as “SMART”, and the picture quality may better than “SMART”.
Video Output
CVBS : Outputs video signal via the composite connector.
Component : Outputs video signal via the component connector.
SCART :
Outputs video signal via the SCART connector.
Component Output
Interlace Scan: When connecting to the TV equipped with Y/Cb/Cr video input.
Progressive Scan: When connecting to the TV equipped with Y/Pb/Pr video input.