Argosy Research Mobile Video HDD - Manual (Page 6)

About the Remote Controller
How to take and store the remote controller
This device is designed with a remote control storage compartment on the bottom. If not in
use, have the remote control stored to the compartment to avoid misplacing.
2
n
o
p
q
Take out the Remote Cntroller Store the Remote Controller
n : Push the bottom of remote forward. p : With the buttons toward up, insert the
top of remote and push it forward. o : The remote will be released from the
stand.
q : Push the bottom of remote to fix it.
Using the Remote for the First Time
Pull out the tab
For the first time using the remote, see the figure shown
alongside and pull out the tab to enable the battery power
of remote
Changing the Battery of Remote
If the battery runs out, change the battery by the following:
1. Looking at the back of the remote controller, press the tab on the left side with your
fingernail n . Hold and pull the indentation with your finger o to take out the old battery.
2. The type of the battery required is [CR2025]. Refer to the illustration below to accurately
insert the battery with the positive side facing up – see attached diagram.
3. Place the new battery and make sure it is inserted and seated securely.
Load the new battery
(+ towards up)
Take out the battery holder Insert the battery holder
n
o