PowerTap SL 2.4 - Manual (Page 10)

3. Place Computer into Shoe
Place the computer into the computer shoe on the handlebar or stem.
Line up the slots on the base of the computer with the bracket and slide
computer toward the rider (FIGURE 5). NOTE: Ensure the computer is fully
inserted onto the receiver shoe to prevent accidental removal.
4 Heart Rate Monitor Strap
Position the heart rate monitor strap on your torso as pictured in FIG-
URE 6. The strap should rest just beneath the pectoralis muscles of
the chest. For best results slightly moisten the electrodes where con-
tact is made with skin. The heart rate strap must be worn to enable
the heart rate function. NOTE: The chest strap for the PowerTap SL2.4
uses a coded frequency and is not compatible with other manufactur-
er’s chest straps. If heart rate is not displayed, consult finding sensors
section.
5. Verify Installation
Check to make sure all components are properly secured. Spin the
rear wheel and verify that in the upper left hand corner of the com-
puter the transmission icon illuminates (FIGURE 7). To turn comput-
er on press either button. The 2.4 computer system may require 30
seconds to “find” the hub. This indicates the hub is properly trans-
mitting a signal to the receiver and computer. If the transmission
icon is not illuminated consult Finding Sensors Section for further
instructions.
10
FIGURE 5
FIGURE 6
FIGURE 7