Ridetech 41230000 User Manual
Page 2
TGR14500 Installation Instructions
• Initial fitment of the floor mount brackets must be done under the carpet. Final installation can
be done under or over the carpet.
• Use Anti-Seize on all fasteners that are threaded into stainless clamps or brackets.
• Install all bars before final tightening.
• Always tighten the tab side of the clamp first.
• Torque all 3/8” fasteners to 45 ft-lbs and all 1/2” fasteners to 75 ft-lbs.
• Make sure the clamp is exactly where you want it before tightening as the clamp may scratch
the tubing.
• Watch for fuel and brake lines when drilling holes through the floor pan.
1. Start by replacing all of the body
mounts with the new polyurethane
mounts included. Using the old
rubber mounts can cause clearance
and fitment issues.
2. Position the main hoop floor
mount so that the front of it is 1 7/8”
behind the front edge of the body
seam on the rocker.
3. Using the bracket as a template;
drill four 3/8” holes through the floor
pan. Drop 3/8” x 1 ¼” bolt w/ flat
washers down through floor pan.