Ridetech 41230000 User Manual
Page 4
11. Using the template on page 7;
drill four 3/8” holes into the top of the
package tray.
12. Attach a “D” Clamp to the main
hoop with the tab facing rearward
with the top of the clamp
approximately 35 9/16” above the
floor mount . Use 3/8” x 1” socket
head cap screws on the clamp.
13. Place the driver side package
tray bar on the package tray and
secure it to the clamp with a ½” x 1
½” 12 point bolt and flange nut.
14. Drop four 3/8” x 1 ¼” bolts with
flat washers down through the bar
mount and the holes in the package
tray.
9. In order to keep the “T” in the
casting facing up, and the bolts
facing the correct direction, there are
two different direction clamps. Be
very careful as to which clamp
halves you are bolting together.
Refer to the image on page 6 for
clamp locations.
10. A correctly assembled clamp
should look like the one in the picture
shown to the left; there should be a
gap on one side for the tab to
slide into.