Ridetech 41230000 - Manual (Page 3)

4. Bolt the inner frame brackets to
the bottom of the floor pan using 3/8”
Nylok nuts and flat washers.
5. The bracket will be fastened to
the frame with two 3/8” x 1” self-
tapping screws. (The frame is boxed
in this section.) The holes must first
be drilled using a 5/16” bit.
7. The outer two holes of the hoop
mount will attach to the outside of the
frame rail with this bracket. Using
the bracket as a template; drill two
3/8” holes into the frame. Use two
3/8” x 1 ¼ bolts, flat washers and
Nylok nuts to secure the bracket to
the frame.
8. Using the bracket as a template;
drill two 3/8” holes into the “B” pillar.
Place this reinforcement plate inside
the quarter. Secure assembly with
two 3/8” x 1 ¾” bolts, flat washers,
and Nylok nuts.
9. Bolt the main hoop to the floor
mounts using four 3/8” x 1” socket
head cap screws.