Ridetech 41160000 User Manual
Page 2
TGR10000 Installation Instructions
• Initial fitment of the floor mount brackets must be done under the carpet. Final installation can
be done under or over the carpet.
• Use Anti-Seize on all fasteners that are threaded into stainless clamps or brackets.
• Install all bars before final tightening.
• Always tighten the tab side of the clamp first.
• Torque all 3/8” fasteners to 45 ft-lbs and all 1/2” fasteners to 75 ft-lbs.
• Make sure the clamp is exactly where you want it before tightening as the clamp may scratch
the tubing.
• Watch for fuel and brake lines when drilling holes through the floor pan.
1. The first bracket to be mounted
needs to be the main hoop floor
mount. It should be mounted to the
wire trough with the front edge of the
bracket exactly 27” behind the front
edge of the seat mount.
2. Using the bracket as a template,
drill the four holes with a 3/8” bit.