Ridetech 41160000 - Manual (Page 5)

14. Bolt the trunk bar mount up to the
package tray, use 3/8” Nylok nut and
flat washers to secure the assembly.
13. The long opening next to the
drilled holes has a lip that will interfere
with the trunk bar mount. The lip must
be flattened; this can be done with a
pair of pliers.
15. Two 3/8” holes must be drilled
through the vertical plane of the
package tray to install the
reinforcement plate. These holes
must be drilled from the trunk.
Secure the plate with two 3/8” x 1 ¼”
bolts, flat washers and Nylok nuts.