Ridetech 41160000 User Manual
Page 4
12. The other end of the bar will
attach to the top of the package tray.
Drop four 3/8” x 1 ¼” bolts with flat
washers down through the package
tray.
7. In order to keep the “T” in the
casting facing up, and the bolts facing
the correct direction, there are two
different direction clamps. Be very
careful as to which clamp halves you
are bolting together. Refer to the
image on page 6 for clamp locations.
8. A correctly assembled clamp
should look like the one in the picture
shown to the left; there should be a
gap on one side for the tab to slide
into.
9. The next bar to be installed is the
package tray bar.
10. Before installing the bar, use the
template on page 7 to drill four holes
in the top of the package tray for the
bar flange to bolt to.
11. Fasten the clamp to the main
hoop with the tab facing rearward.
Use clamp D on the driver side and
clamp P on the passenger side.