Ridetech 41160000 - Manual (Page 3)

3. The upper portion of the bracket
will fasten to the wire trough with a
reinforcement plate inside the trough.
A 1 ¼” access hole must be drilled (¾”
in front of the bracket and 7/8” from
the top of the trough)
reinforcement plate through. Use
3/8” x 1 ¼” bolts, flat washers and lock
washers to secure the bracket. A
plastic plug is supplied to cover the
access hole.
4. Fasten the main hoop to the
mounts using 3/8” x 1” Socket Head
Cap Screws and lock washers
5. Secure the lower portion of the
bracket to the floor pan with two 3/8” x
1 ¼” bolt, flat washers and Nylok nuts.
Another reinforcement plate will be
installed under the car. It will also
meet up with the pinch weld.
6. Two more 3/8” holes must be
drilled through the pinch weld. 3/8” x
1” bolts, flat washers and Nylok nuts
will be used here.
3. The upper portion of the bracket
will fasten to the wire trough with a
reinforcement plate inside the trough.
A 1 ¼” access hole must be drilled (¾”
in front of the bracket and 7/8” from
the top of the trough) to slide the
reinforcement plate through. Use
3/8” x 1 ¼” bolts, flat washers and lock
washers to secure the bracket. A
plastic plug is supplied to cover the
4. Fasten the main hoop to the
mounts using 3/8” x 1” Socket Head
nd lock washers.
5. Secure the lower portion of the
bracket to the floor pan with two 3/8” x
1 ¼” bolt, flat washers and Nylok nuts.
Another reinforcement plate will be
installed under the car. It will also
meet up with the pinch weld.
re 3/8” holes must be
drilled through the pinch weld. 3/8” x
1” bolts, flat washers and Nylok nuts
will be used here.