Speedtech Nova Subframe - Manual (Page 3)

3 | P a g e
Assembling the Sub Frame
1. Support the sub frame with jack stands at each corner, be sure it is sturdy
and level.
2. Install the supplied motor mounts. Do not fully tighten the bolts at this time to
allow adjustment later when installing the engine.
Note: LS Series motors use 2 different length frame pads, the Taller Pad must be installed
on the Driver Side.
This will move the motor over ¾” to clear the oil pan rail. You must also us
an LS motor mount adapter such as the ATS # 070001.
Small Block and Big Block engine stands are equal in height and can be installed on either
side.