Telenav for AT&T Supported Devices: v4.1 for iPAQ 6920, 6925 - Manual (Page 9)

© TELENAV 2003-6 PAGE 9 OF 27
Registration
The next screen will notify you that you will need your 10-digit phone
number, also referred to as an account number, and your 4-digit PIN.
NOTE: Your account number MUST be the same as your carrier phone
number beginning with area code so that when you call the Voice
Address Input System you will not need to type in the account number.
Input your TeleNav account number and the PIN you provided when
registering for TeleNav services at
www.telenav.com .
After you have entered the account number and 4-digit PIN, press the
Submit button.
A warning message will be displayed, press OK to complete the setup
process.
NOTE: If your TeleNav account is not active, you will be notified at this
point, and will be directed to go to www.telenav.com to extend your
service agreement. You will not be able to progress beyond this point
until your account is returned to current status. You may also see an
important message from TeleNav regarding upgrades, scheduled
downtime, pending account expiration, etc.
When the handheld reaches the TeleNav servers with a valid and active
phone number and PIN, the handheld will be registered to use TeleNav,
and will not present any of the above screens except the splash screen in
the future. Visiting
www.telenav.com , and changing the PIN will require
you to repeat the above registration process.