Tuff Country 14059 - GM 2014 Silverado 1500 4wd 4 lift kit - Manual (Page 11)

31. Working on the driver side, install the OE end link to the
sway bar and lower control arm. Make sure to use loctite and
hand tighten.
32. Carefully re-connect all (3) electric wiring harnesses
back to the rack and pinion.
33. Install the OE skid plate using the OE hardware. Make
sure to use loctite and torque to 40 ft lbs.
34. Working on the driver side, center and torque the OE
cam bolts to 95 ft lbs. Repeat procedure on the passenger
side.
35. Working on the driver side, grease the upper control arm
bushings and ball joint. Repeat procedure on the passenger
side. Special note to the customer: Make sure to have
the upper control arm bushings and ball joints greased
each time you have the oil changed.
36. Check and double check and check again to make sure
all steps have been performed properly with the front end.
37. Install the tires and wheels and carefully lower the vehi-
cle to the ground.
38. To begin installation, carefully block the front tires and
wheels so that the vehicle can not roll forward. Safely lift the
rear of the vehicle and support the vehicle with a pair of jack
stands. Place a jack stand on both the driver and the pas-
senger side. Next, remove the rear wheels and tires from
both sides.
39. Working on the driver side, remove the ABS line from the
bottom of the frame rail. Remove the plastic clip and discard.
Repeat procedure on the passenger side.
40. Place a pair of hydraulic floor jacks under the rear differ-
ential. Carefully raise up on the hydraulic floor jacks until
they make contact with the rear differential.